ETRI-Knowledge Sharing Plaform

ENGLISH

성과물

논문 검색
구분 SCI
연도 ~ 키워드

상세정보

학술지 Characterization of an ASE Reflector-Based Gain-Clamped Erbium-Doped Fiber Amplifier
Cited 8 time in scopus Download 0 time Share share facebook twitter linkedin kakaostory
저자
안준태, 서홍석, 정운진, 박봉제, 김경헌
발행일
200503
출처
IEEE Photonics Technology Letters, v.17 no.3, pp.555-557
ISSN
1041-1135
출판사
IEEE
DOI
https://dx.doi.org/10.1109/LPT.2004.842380
협약과제
04MB6100, L+ 밴드대 광증폭기용 광섬유 및 소자 개발, 안준태
초록
We develop a simulation tool for an all-optical gain-clamped erbium-doped fiber amplifier (GC-EDFA) based on an amplified spontaneous emission (ASE) reflector and thoroughly verify its validity by comparing simulation data with experimental ones. We carry out simulation work as changing conditions like reflection ratio and bandwidth of the ASE reflector, EDF length, and pump power. From this work, we have an exact understanding about the gain clamping principle that a reflected ASE acts like an intensity reservoir against input signal intensity variation. In general, as a reflected ASE power becomes higher, both a dynamic range and a noise figure (NF) increase; on the other hand, a clamped gain value decreases. The ASE reflector-based gain clamping scheme can be used for EDFAs with low NF characteristics at small input signal range in case a reflected ASE power is set at a level much lower than powers required for normal gain clamping function. © 2005 IEEE.
KSP 제안 키워드
Carry out, Clamping scheme, GC-EDFA, Gain clamping, Input signal, Intensity variation, Noise Figure(NF), Optical Gain, Pump power, Signal intensity, Simulation data