Journal Article
Electrical and optical analysis on effects of low-temperature-grown p-AlGaAs cladding layer in all-MOCVD InAs/GaAs quantum dot laser diodes
In this work, we investigate how low-temperature growth of the p-AlGaAs cladding layer affects the structural and device characteristics of all-metal-organic chemical vapor deposition (MOCVD)-grown InAs/GaAs quantum dot laser diodes (QDLDs) operating in the O-band. While reduced-temperature p-AlGaAs growth is required to suppress degradation of the strained dots-in-a-well (DWELL) active region, its direct device-level impact has remained insufficiently clarified. Here, we show that, although dislocation-related morphology is shown in the p-AlGaAs cladding, the underlying DWELL active region remains largely preserved. Cross-sectional transmission electron microscopy and etch-dependent photoluminescence measurements further indicated that the structural non-uniformity was mainly confined to the upper cladding rather than associated with irreversible active-region degradation. Electrical current-component analysis showed that the bulk injection path was only weakly affected and that the surface-related current contribution was negligible. Based on these results, 1.5-mm-cavity shallow-ridge devices were fabricated and evaluated under continuous-wave operation. After high-reflectivity coating, the threshold current decreased from 125.5 to 65.5 mA and the slope efficiency increased from 0.084 to 0.128 W/A. The device also exhibited a lasing linewidth of 6.8 MHz and relatively low near-threshold relative intensity noise. These results show that low-temperature p-AlGaAs cladding growth can be used to realize all-MOCVD-grown InAs/GaAs QDLDs without imposing a severe electrical or optical degradation.
KSP Keywords
Cladding layer, Device characteristics, Electron Microscopy(TEM and SEM), High-reflectivity coating, InAs/GaAs quantum dot, Laser diodes, Low-temperature growth, Metalorganic chemical vapor deposition, Non-uniformity, Optical degradation, Quantum dot laser(QDL)
Copyright Policy
ETRI KSP Copyright Policy
The materials provided on this website are subject to copyrights owned by ETRI and protected by the Copyright Act. Any reproduction, modification, or distribution, in whole or in part, requires the prior explicit approval of ETRI. However, under Article 24.2 of the Copyright Act, the materials may be freely used provided the user complies with the following terms:
The materials to be used must have attached a Korea Open Government License (KOGL) Type 4 symbol, which is similar to CC-BY-NC-ND (Creative Commons Attribution Non-Commercial No Derivatives License). Users are free to use the materials only for non-commercial purposes, provided that original works are properly cited and that no alterations, modifications, or changes to such works is made. This website may contain materials for which ETRI does not hold full copyright or for which ETRI shares copyright in conjunction with other third parties. Without explicit permission, any use of such materials without KOGL indication is strictly prohibited and will constitute an infringement of the copyright of ETRI or of the relevant copyright holders.
J. Kim et. al, "Trends in Lightweight Kernel for Many core Based High-Performance Computing", Electronics and Telecommunications Trends. Vol. 32, No. 4, 2017, KOGL Type 4: Source Indication + Commercial Use Prohibition + Change Prohibition
J. Sim et.al, “the Fourth Industrial Revolution and ICT – IDX Strategy for leading the Fourth Industrial Revolution”, ETRI Insight, 2017, KOGL Type 4: Source Indication + Commercial Use Prohibition + Change Prohibition
If you have any questions or concerns about these terms of use, or if you would like to request permission to use any material on this website, please feel free to contact us
KOGL Type 4:(Source Indication + Commercial Use Prohibition+Change Prohibition)
Contact ETRI, Research Information Service Section
Privacy Policy
ETRI KSP Privacy Policy
ETRI does not collect personal information from external users who access our Knowledge Sharing Platform (KSP). Unathorized automated collection of researcher information from our platform without ETRI's consent is strictly prohibited.
[Researcher Information Disclosure] ETRI publicly shares specific researcher information related to research outcomes, including the researcher's name, department, work email, and work phone number.
※ ETRI does not share employee photographs with external users without the explicit consent of the researcher. If a researcher provides consent, their photograph may be displayed on the KSP.